Owner`s manual

CHANNEL SETUP unit

5 CTRL RESET

Determines whether the control value is reset or maintained for each MIDI channel when

the program is switched by a program change message or other mean. Select ON to reset

or NO to maintain. MIDI channels B01 through B16 are not available on the A4000.

6 NOTE ON TYPE

Selects the type of playback which will occur when note-on messages are received for

each MIDI channel. MIDI channels B01 through B16 are not available on the A4000.

PROGRAM LFO unit

7 WAVE

Selects the PROGRAM LFO waveform. The selected waveform is used to modulate the

sound in synchronization with the received MIDI clock and the playback tempo.

8 CYCLE

Selects the note type corresponding to the one PROGRAM LFO cycle.

9 INIT PHASE

Selects the initial phase of the PROGRAM LFO.

) SYNC

Selects the PROGRAM LFO synchronization method. MANUAL allows the PROGRAM LFO

to be synchronized to the specified tempo, and MIDI allows the PROGRAM LFO to be

synchronized to a received MIDI clock.

! TEMPO

Sets the tempo for MANUAL synchronization. This has no effect when MIDI synchronization

is selected.

@ RESET CH

Specifies the MIDI channel via which a received note-on message will initialize the phase

of the PROGRAM LFO when MANUAL synchronization is selected. This has no effect when

MIDI synchronization is selected.

# NOTE

Specifies the note number which will initialize the phase of PROGRAM LFO. This has no

effect when MIDI synchronization is selected.

$ VALUE

Sets the values for STEP 1 through 16 of the step wave waveform. This has no effect on

waves other than the step wave.

% SLOPE

Selects the method by which the step wave steps will be smoothly connected. This has no

effect on waves other than the step wave.

^ TOTAL STEPS

Sets the total number of steps for the step wave. Values for steps beyond the total step

number have no effect.

se_e.qx 9/16/99 12:14 PM Page 12