Specifications

Installing Optional Equipment
● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● A5000/A4000 • Appendix 239
7.In the same way, connect the other red-and-white cable (4-wire) to the CN1, CN2, or
CN4 connector shown in the illustration.
• If no internal hard disk or ZIP drive is installed, all three connectors will be available. Any of these con-
nectors can be used.
• If at any time you need to disconnect any of these connectors, do so while pressing the release clip on the
plug. Do not apply excessive force.
The expansion board is now fully installed.
There is no need to remove the expansion board when installing other devices.
8.Secure the red/white cables and the wide flat cable to the bundle tie.
• Run the flat cable, the 3-wire cable, and the 4-wire cable through the bundle tie (see illustration below).
Adjust the tie so that the cables are secure.
9.Replace the top cover (page 233).
10.Plug in the power cord.