User Manual
Table Of Contents
- Copyright
- About Audinate
- Introduction
- Installing Dante Controller
- Dante Basics
- Discovery and auto-configuration
- Device Channels
- Differentiating between input and output channels
- Device Names and Channel Labels
- Routing Audio
- Clock Synchronization
- Latency
- Device Lock
- Dante Control and Monitoring
- Starting Dante Controller
- Using Dante Controller
- Network View
- Status Bar
- Network View Tabs
- Channel Groups
- Clock Status Monitoring
- Clock Status Monitor
- Automatic Notification of Device Errors
- Device View
- Device View Tabs
- Multicast Transmit Flow Configuration
- Using Dante Controller with Dante Domain Manager
- Presets
- Troubleshooting
- Fanout
- Messages on Startup
- Computer Configuration Checklist
- Troubleshooting Dante IP Address Configuration
- Troubleshooting Switch Configuration and Cabling
- Index
Dante Controller User Guide
Copyright © 2018 Audinate Pty Ltd. All rights reserved.
-93-
Parameter Rules
Rx Subscriptions
If ‘Rx Subscriptions’ are included in the preset, and applied to the target system (i.e. ‘Rx Subscriptions’ is
checked in the Advanced > Parameters column when the preset is saved, and also checked in the Preset
Elements column when the preset is applied):
All subscriptions for all matched devices on the target system will be updated to match the source system.
This means that:
n All subscriptions saved into the preset will overwrite the respective subscriptions for matched
devices on the target system. If the subscriptions are identical, they are maintained.
n Any existing subscriptions on the target system that do not exist in the preset will be removed,
regardless of whether any subscriptions are defined in the preset.
Tx Flows (multicast flows)
The behaviour for TX Flows and Tx Channel Labels is different to that of Rx Subscriptions.
If ‘Tx Flows’ are included in the preset, and applied to the target system (i.e. ‘Tx Flows’ is checked in the
Advanced > Parameters column when the preset is saved, and also checked in the Preset Elements
column when the preset is applied):
n All Tx flows saved into the preset will overwrite the respective Tx flows for matched devices on the
target system.
n Any Tx flows on the target system that do not exist in the preset will be removed, if at least one Tx
flow is defined in the preset. Otherwise (i.e. if no Tx flows are defined in the preset), all Tx flows on
the target system are maintained (note this is different to how Rx subscriptions are handled).
n Multicast flows and/or transmit channel names can be manually deleted from the target device prior
to or following the preset application.
Tx Channel Labels
The behaviour for Tx channel labels is identical to the Tx flows behaviour described above.
Applying Presets
To load and apply a saved preset, select File > Load Preset from the main menu (Ctrl + L).
Legacy preset files are supported.
The 'ApplyPreset' dialogue is arranged in 4 columns, representing the logical steps in applying a preset
(from left to right).