User Manual

About the DANTE ACCELERATOR
DANTE ACCELERATOR
Getting Started 9
English
Status LEDs
The status LEDs indicate the following
conditions:
SYS – Indicates the status of the Dante
system.
SYNC – Indicates the clock
synchronization status of the Dante
device.
ERR – Indicates an error.
NOTE
All LEDs will flash green when the card's
Identify function has been activated using
the Dante Controller or web interface.
A green light indicates the system
has booted successfully and is
operating properly.
The SYS LED will be amber while
the system is booting. If it persists,
the system has failed to boot
correctly.
A solid green light indicates that
the device is a Dante PTP
(protocol used to allow sample-
accurate synchronization for the
whole network) clock slave and is
synchronized to the PTP master.
A flashing green light indicates
that the device is the Dante PTP
clock master.
An orange light indicates a
network synchronization error.
Obtaining network sync may take
up to 45 seconds.
A solid red light indicates that the
Dante Accelerator has encountered
errors on boot and entered failsafe
mode. In this case, the SYS and
SYNC LEDs are also solid red.
When in failsafe mode, the Dante
Accelerator must be fixed with
Dante Firmware Update Manager.
For details, refer to the user manual
for Dante Firmware Update
Manager available from the
following website:
http://www.yamahaproaudio.com/