Owner's Manual

52
Voice Select
You can select a voice for play from among the
128 voices in memory. There are two procedures
for doing so, as listed below.
Procedure 1
1. Enter a number between [1] and [128] in
the PROGRAM CHANGE keypad. The voice
number that you enter will start flashing
in the LCD.
When the voice number is flashing, pressing [NO] will cancel the voice select
operation and the LCD will revert to the previous condition.
2. When the voice number is flashing,
pressing [YES/ENTER] will call up the voice
assigned to the number which you
entered.
The voice name, voice Category and voice number will
display in the LCD, along with the Poly mode, Layer
mode and Arpeggiator/Sequencer (on/off) status.
For additional information see Poly mode, page 72, Layer mode, page 22,
Arpeggiator, page 33, and Step Sequencer, page 37.
ABC
0
VWX
MNO
7
YZ
8
PQR
5
GHI
2
–
4
DEF
1
OTHERS
STU
9
6
JKL
3
YES/ENTERNO
Voice Category
Voice name
Poly mode, Layer mode
and Arp/SEQ status
Voice number
ABC
0
VWX
MNO
7
YZ
8
PQR
5
GHI
2
–
4
DEF
1
OTHERS
STU
9
6
JKL
3
YES/ENTERNO
Procedure 2
1. Press [+] to increment through the voices
sequentially.
2. Press [-] to decrement through the voices
sequentially.
In this case you do not need to press [YES/ENTER], as
the voice is called up with each press of the [+] or [-]
key.
When a voice is selected, a MIDI Program Change
message is transmitted to the AN1x’s internal tone
generator and the MIDI [OUT] terminal. Voice numbers
001 ~ 128 correspond to Program Change numbers
000 ~ 127, respectively. (For information about MIDI,
see page 109.)
PROGRAM CHANGE
VWX
MNO
7
YZ
8
PQR
5
GHI
2
–
4
DEF
1
ABC
0
OTHERS
STU
9
6
JKL
3
YES/ENTERNO
This section provides a list of the many AN1x parameters and a description of each for reference
purposes. Check the CONTENTS or INDEX to locate the page number of the parameter you need.