Owner's Manual

73
Settings:
poly: You can play maximum 10 notes polyphony when
Layer mode is set to SINGLE.
mono: Plays one (monophonic) note.
legat (Legato): Plays one (monophonic) note, and provides
for legato phrasing, or solo passages played without any
perceptible interruption between notes. Legato occurs when
you press the next key before releasing the preceding key.
● Port (Portamento)
The Portamento mode setting determines the
characteristics of the portamento (sometimes called
glissando), or how the tone glides from one tone to the
next through all the intermediate pitches, when the
PEG/LFO Portamento Time (see page 56) is set to a
value other than “0”. Available parameters depend on
the Poly mode setting.
To enable the Portamento function, press the [PORTAMENTO] switch on the panel
(see page 24). If the PEG/LFO Portamento Time parameter (see page 56) is set
to "0", Portamento will have no effect.
Settings:
When Poly = Poly:
normal: Normal portamento play.
sus-key: With this setting, the Hold tone (by a sustain pedal)
is specified as the starting pitch of the portamento.
When Poly = Mono, Legato:
fingerd (Fingered): Portamento is only enabled by legato
performance.
full time: Portamento is always enabled.
The Portamento setting mode here is effective and can be heard when the panel
[PORTAMENTO] switch is set to "ON".
● LFO Rst (LFO Reset)
The LFO Reset mode setting determines the start point
of the LFO1 and LFO2 cycle.
Settings:
off: LFO1 and LFO2 do not reset, but modulate continuously.
ky-on (Key On): LFO1 and LFO2 reset every time a key is
pressed.
Ctrl Matrix (Control Matrix)
Control Matrix (“Ctrl Matrix”) parameter settings
determine which MIDI Control Change number
“source” controller (eight panel CONTROL knobs,
Modulation Wheel, Foot Controller, Ribbon-X,
Keyboard After Touch, etc.) is assigned to control
which AN1x “parameter” (VCF Cutoff, Resonance,
FEG Depth, Variation Effect Wet:Dry balance, etc.).
The Control Matrix gives you the freedom to configure
sources and parameters for each voice. You can, for
example, configure the AN1x to use After Touch to
apply vibrato, or the Modulation Wheel to change the
resonance while you play, determine the range for both
Pitch Bend up and down, and much more.
The Control Matrix is a configuration of 16 sets of
control setup parameters and 2 sets of common
parameters. The 16 parameter sets apply to each
Scene and the common parameters apply to the voice.
Each set consists of Set Number, Parameter, Source,
and Depth parameters.
A blank chart is available for writing down Parameter and Source settings of the
Control Matrix; see page 114.