Owner's Manual

89
SEQ EDIT/SETUP
This menu includes parameters and settings related to
creation and play of Step Sequencer patterns. You can
create a Voice Pattern for each voice, as well as create
and store a total of 128 User Patterns. Step Sequencer
settings are stored as voice data.
When the [EDIT ROTARY] switch is set to the SEQ EDIT/SETUP menu, the eight
CONTROL knobs are used to set event data for each of the 16 steps. For
information about using the Step Sequencer, see page 37.
Knob
Knob parameters are related to the 16 sequencer
steps. There are three parameters available, including
Event, 1-8/9-16, and Step Hold.
● Event
The Event parameters let you designate the type of
event data to input using the eight CONTROL knobs.
Settings: Note (0 ~ 127 (C-2 ~G8)), Velocity (0 ~ 127),
Gate Time (1 ~ 200%), Control Change (off, 1 ~ 95, AT)
Control Change setting (off, CC1~95, After Touch) is determined by the Control
Number parameter in the same menu row (see page 91).
Knob
Event
1-8/9-16
SEQ
EDIT/SETUPStep Hold
Pattern
Bank
No
BaseUnit
Length LoopType Ctrl No
SEQ
Store
● 1-8/9-16
This parameter lets you designate which series of steps
(1-8 or 9-16) are available for data entry using the
eight CONTROL knobs. Each knob as positioned on
the panel (1-8) relates to the corresponding sequence
step (either 1-8 or 9-16, respectively), depending on
this setting.
Pressing a knob for parameter confirmation or turning it for data input will display
its step number in the LCD, to the left of the value setting.
Settings: 1-8, 9-16
● Step Hold
The Step Hold parameter lets you turn the Step Hold
function on and off. When Step Hold is set to “on”, the
note of the currently selected step will play repeatedly,
based on the Tempo and Pattern Base Unit settings.
This lets you adjust the various Event settings in context
with the speed and timing of the sequence.
When Step Hold is set to “on”, you can select and check a step parameter by
pressing a knob’s push-switch or turning it.
Settings: on, off