Owner's Manual
2. Press [YES/ENTER] to initiate the bulk dump.
When the operation is finished, “End” will
appear briefly in the LCD, which will then return
to its prior display.
To stop a bulk dump operation in progress, press [NO]. The
LCD will return to its prior status.
Receive Bulk Dump
A Receive Bulk Dump operation lets you load data back into
the AN1x from an external MIDI device.
The type of data which can be received depends on the
current mode. For more information, see the MIDI data
format, in the separate Data List book.
Before initiating a Receive Bulk Dump operation, the Device
Number for both devices must be matched. (For more
information, see Device No, on the previous page.)
ABC
0
VWX
MNO
7
YZ
8
PQR
5
GHI
2
–
4
DEF
1
OTHERS
STU
9
6
JKL
3
YES/ENTERNO
Ctrl (Control)
Control parameters let you designate the type of
Control Change messages which can be controlled by
the [MODULATION] Wheel, each of the eight
CONTROL knobs, the [RIBBON] Controller, etc., by
assigning Control Change numbers to specific
controllers ("devices"). There are two parameters
available, Device and Control Number.
Based on settings made here as well as in the Control
Matrix (see pages 51, 73), you can use a single
controller to control one parameter of the internal tone
generator and another parameter of an external MIDI
device, both at the same time. It also lets you
determine which device (MW, FC, etc.) to use for
Scene Control.
● Device
The Device parameter lets you select the controller to
which you want to assign a Control Number.
● Ctrl No (Control Number)
The Control Number parameter lets you designate the
Control Change number (type of parameter) which the
Device (controller) will control.
For information about MIDI and MIDI Control Change messages, see page 109.
Settings: 0 (off), CC 1 ~ 95, After Touch
Procedure
1. Press Device [UP/DOWN] to select the name of
the controller to which you want to assign a
controller number.
Controllers:
MW: Modulation Wheel
FV: Foot Volume
FC: Foot Controller
FS: Footswitch
RbnX: Ribbon Controller X-axis
RbnZ: Ribbon Controller Z-axis
Knob1~8: Assign group knobs 1 ~ 8
SCENE: Scene Control controller
95