Owner`s manual

E-2
GETTING STARTED
Battery installation
Since the remote control will be used for many of this unit’s
control operations, you should begin by installing the
supplied batteries.
1 Turn the remote control over and remove the battery
compartment cover by sliding it in the direction of
the arrow.
2 Insert the batteries (AA, R6, UM-3 type) according to
the polarity markings on the inside of the battery
compartment.
3 Close the battery compartment cover.
Battery replacement
If you notice that the remote control must be used closer to
the main unit, the batteries are weak. Replace both
batteries with new ones.
Notes
● Use AA, R6, UM-3 batteries.
● Be sure the polarities are correct. (See the illustration inside
the battery compartment.)
● Remove the batteries if the remote control is not to be used for
an extended period of time.
● If the batteries leak, dispose of them immediately. Avoid
touching the leaked material and avoid contact with clothing,
etc. Clean the battery compartment thoroughly before
installing new batteries.
USB
POWER
PC
AUX1
AUX2
JAZZ CHURCHHALL
B
VOLUMEMUTE
CA
MOVIE LIVEGAME
TEST ON / OFF VDD
2
1
3
Remote control operation range
Notes
● The area between the remote control and the main unit must
be clear of large obstacles.
● Do not expose the remote control sensor to strong lighting, in
particular, an inverter type fluorescent lamp; otherwise, the
remote control may not work properly. If necessary, position
the main unit away from direct lighting.
USB
PC
AUX1
AUX2
DSP MUTE
VOL
VIRTUAL 5.I CH
DIGITAL
PROLOGIC FMAM ST
USB PCM D.
DSP
30°
30°
Remote control
sensor
Unpacking
After unpacking, check that the following items are
supplied.
● Remote control
● CD-ROM
The CD-ROM contains
the Application Software
and online help for
controlling this unit from
your computer.
● Batteries (AA, R6, UM-3
type)
● USB cable
Within
approximately
6 m (19.7 feet)