Electronic Keyboard User's Manual

Keyboard Stand Assembly
YDP-160/140 Owner’s Manual
35
Keyboard Stand Assembly
CAUTION
• Be careful not to confuse parts, and be sure to install all parts in the correct direction. Please assemble in accor-
dance with the sequence given below.
• Assembly should be carried out by at least two persons.
• Assemble the stand on the flat floor surface.
• Be sure to use the included screws only, and insert screws of the correct size in the correct hole locations. Use of
incorrect screws can cause damage or malfunction of the product.
• Be sure to tighten up all screws upon completing assembly of each unit.
•To disassemble, reverse the assembly sequence given below.
Remove all parts from the package and make sure you
have all of the items.
1. Attach (finger-tighten) C to D
and E.
1-1 Untie and straighten out the bundled pedal
cord. Don’t discard the vinyl tie. You will
need it later in step 6.
1-2 Align D and E with each end of C.
1-3 Attach D and E to C by finger-tightening the
long screws 1 (6 × 20mm).
Have a Phillips-head (+) screwdriver ready
DE
A
B
C
Bundled pedal cord
inside
AC Power cord (YDP-160)
AC Power adaptor (YDP-140)
Assembly Parts
6 × 20 mm long screws × 4
1
6 × 16 mm short screws ×4
2
4 × 12 mm thin screws ×2
3
4 × 20 mm tapping screws × 4
4
Cord holders × 2
Headphone hanger set (YDP-160 only)
4 × 10 mm thin screws ×2 5 Headphone hanger
L
1-2
1-1
1-3
D
E
C
33