Owner's Manual
Table Of Contents
• Bi-wire connection
The bi-wire connection separates
the
woofer from the
combined midrange and tweeter section. A bi-wire
compatible speaker
has
four binding post terminals. These
two
sets
of
terminals allow the speaker
to
be
split into two
independent sections. This split connects the
mid
and high
frequency drivers
to
one set of terminals and the
low
frequency driver
to
the other
pair.
Caution
To
lise
the
bi-wire connections,
the
impedance
of
each speaker
mList
be
8 n or higher.
Notes
• Remove the shorting bars or bridges
to
separate the
LPF
(low
pass filter) and
HPF
(high pass lilter) crossovers.
•
To
Lise
the bi-wire connections, switch
the
SPEAKERS selector
to
the
A+S SI-WIRING position.
• Connecting to the CD BAL jacks
Connect your
CD
player with the
XLR
balanced output
jacks. The pin assignments for these jacks are shown
below. Refer
to
the owner's manual supplied with your
CD
player and verify that its XLR balanced output jacks
are compatible with the
pin
assignments.
2: hot
&
1:
ground
~
3: cold
When connecting,
be
sure
to
match
the
pins and insert the
connector
of
the "male" XLR balanced cable until
you
hear a "click". When disconnecting, pull out the "male"
XLR balanced cable while holding down the lever
of
the
CD SAL jacks.
"Female"
XLR connector
"Male"
XLR connector
Note
To
Lise
the
XLR balanced connection, you must switch
the
INPUT selector
on
the
front panel
to
the CD
SAL
position.
17
En