Owner's Manual
Table Of Contents
PLA YING
AND
RECORDING
•
Adjusting
the
LOUDNESS
control
Retain a full tonal range at any volume level, thus
compensating for the human ears' loss
of
sensitivity to
high and low-frequency ranges at low volume.
Play
the
source and begin recording on
recording device connected
to
the
REC
output
jacks (LINE 2 and/or LINE 3) on the
rear panel. See page 6.
2
1
1 Rotate the
REC
OUT selector on the
front
panel
to
select the source you want
to
record.
,0,
~ii>~
•
If
you select the same source with the INPUT selector as you
select with the REC OUT selector, you can monitor the
recording.
• To listen to another input source without affecting the current
record out signal, select the source with the INPUT selector.
• The audio signals are not output via the LINE 2 REC or LINE 3
REC output jacks when LINE 2 or LINE 3
is
selected with the
REC OUT selector.
The audio signals are output at both LINE 2 REC and LINE 3
REC output jacks
if
you select PHONO, TUNER, CD or LINE
I.
• The VOLUME, BASS, TREBLE, BALANCE and
LOUDNESS controls and the CD DIRECT AMP switch (and
the PURE DIRECT switch) have
no
effect on the source being
recorded.
• Check the copyright laws in your country to record from
records, CDs, radio, etc. Recording copyright-protected
material may infringe on copyright laws.
Remote
control
or
Front panel
Rotate the LOUDNESS control until the
desired volume
is
obtained.
3
2 Rotate VOLUME on the
front
panel
(or
press
VOL
+/-
on the remote control)
to
set the
sound
output
level
to
the loudest listening
level that you would listen to.
(
.~'~
...
."
'I'~'
. "
CAUTION
If
the CD DIRECT AMP switch (or the PURE DIRECT
switch)
is
turned on with the LOUDNESS control set at a
certain level, the input signals bypass the loudness control,
resulting
in
a sudden increase
in
the sound output level. To
prevent your ears or the speakers from being damaged, be
sure to press the CD DIRECT AMP switch (or the PURE
DIRECT switch) AFTER lowering the sound output level
or AFTER checking that the LOUDNESS control
is
properly set.
1 Set the LOUDNESS control
to
the FLAT
position.
,0,
~ii>~
After setting the LOUDNESS control, enjoy listening to music at
your preferred volume level
by
controlling VOLUME.
If
the
effect
of
the loudness control is too strong
or
weak, readjust the
LOUDNESS control.
I
11
En