Owner's Manual
Table Of Contents
TROUBLESHOOTING
Problems
Possible
Causes
Solutions
Refer
to
page
No sound
Sound is muted.
Press MUTE on the remote control to resume the
3
audio output.
Incorrect cable connections.
Connect the stereo cable for audio units and the
speaker wires properly.
If
the problem persists, the
6
cables may be defective.
No appropriate input source has been Select
an
appropriate input source with the INPUT
selected. selector on the front panel (or one
of
the input 9
selector buttons on the remote control).
The SPEAKERS selector is not set Set the corresponding SPEAKERS selectorto A, B or
9
properly.
A+B position.
The sound SUddenly The protection circuitry has been activated Check that the IMPEDANCE SELECTOR setting is
5
goes off.
because
of
a short circuit, etc. correct.
Check that the speaker wires are not touching each
other or shorting out against the rear panel
of
this 6
unit, and then
tum
the power
of
this unit back on.
Only the speaker
on
Incorrect cable connections.
Connect the cables properly
[I'the problem persists,
6
one side can
be
the cables may
be
defective.
heard.
Incorrect setting for the BALANCE Set the BALANCE control to the appropriate
10
control. position.
There Is a lack
of
The + and - wires are connected
in
Connect the speaker wires
to
the correct + and -
bass and no
reverse at the amplifier or the speakers. phase. 6
ambience.
A "humming" sound
Incorrect cable connections. Connect the audio plugs firmly.
If
the problem
6
can be heard.
persists, the cables may be defective.
No connection from the turntable
to
the Make the GND connection between the turntable and
6
GND
terminal. this unit.
The volume level is The turntable is connected to the jacks Connect the turntable
to
the PHONO jacks.
6
low while playing a
other than the PHONO jacks.
record.
The record is being played on a turntable Use a turntable equipped with an MM cartridge.
-
with an MC cartridge.
The volume level The component connected to LINE 2 REC
Tum
on the power
of
the component.
cannot be Increased, or LINE 3 REC terminals
of
this unit is
or the sound is turned off.
-
distorted.
The sound is
The power
of
this unit
is
turned off, or this Turn on the power
of
this unit.
degraded when unit
is
set to the standby mode.
listening with the
headphones
9
connected to the CD
player or the tape
deck connected to
this unit.
The sound level is
The LOUDNESS control is functioning. Set the LOUDNESS control to the FLAT position.
11
low.
The input source
The
CD
DIRECT
AMP
switch is turned
Tum
off
the
CD
DIRECT AMP switch.
cannot be changed on.
10
although the INPUT
selector
is
rotated.
Using the BASS,
The CD DIRECT
AMP
switch or the The CD DIRECT AMP switch or the PURE DIRECT
TREBLE, BALANCE PURE DIRECT switch is turned on. switch must
be
turned
off
to use those controls.
and LOUDNESS
10
controls does not
affect the tonal
quality.
13
En
I