Owner's Manual

5
En
Installation
The orientation of the sound bar and the appropriate
remote control sensor depend on the installation
location.
Installing the sound bar on a TV cabinet,
etc.
1 Slide the installation position selector switch on
the bottom panel of the sound bar to the T (for
Tabletop) side (T, by default).
The sound quality appropriate to the installation will
be s
et.
2 Place the sound bar on a TV cabinet, etc., so that
th
e keys are facing the wall.
Attaching the sound bar to a wall
1 Slide the installation position selector switch on
the bottom panel of the sound bar to the W (for
Wall mount) side.
The sound quality appropriate to the installation will
be set
.
2 Following “How to install on the wall” below, install
t
he sound bar so that the keys face upwards.
How to install on the wall
1 Attach the mounting template on a wall and mark
fo
r the screw holes.
2 Remove the mounting template from the wall,
th
en install commercially available screws (as
illustrated below) at the points marked on the
wall.
3 Peel off the backing paper from the spacers and
at
tach the adhesive face to the sound bar as
illustrated below.
4 Hang the sound bar on the screws.
Cautions
• Do not stack the sound bar and a BD player or other device
directly on each other. Doing so may cause a malfunction due to
vibrations.
• Do not hold the speaker portion (fabric parts) on the front and the
top of the sound bar.
• The sound bar contains non-magnetic shielding speakers. Do not
place magnetically sensitive items (h
ard disk drive, etc.) near the
sound bar.
• Depending on your installation environment, it may be better to
connect the sound bar a
nd external devices (such as a TV)
before installing the sound bar.
• Do not place the sound bar within 50 mm (2") of the TV.
Installation position
selector switch
(bottom panel)
Remote control sensor
(front panel)
Cautions
• When installing the sound bar on a wall, all installation work must
be performed by a qualified contractor or dealer. The customer
must never attempt to perform this installation work. Improper or
inadequate installation could cause the sound bar to fall,
resulting in personal injury.
• To avoid falling the sound bar, attach the sound bar to a dry wall.
• Make sure you use commercially available screws that can
support the
weight of the installation (specified in Step 2 on the
right). Using clamps other than specified screws, such as short
screws, nails, and two-sided tape, may cause the sound bar to
fall.
Remote control
sensor (top panel)
Keys
Installation position selector
switch (bottom panel)
Tapes or thumbtacks
Mounting template (supplied)
Screw
holes
Cautions
• Fix the cables in place where they will not become loose. If your
foot or hand accidentally gets caught on a loose cable, the sound
bar may fall.
• Check that the sound bar is fixed securely after the installation.
Yamaha will bear no responsibilit
y for any accidents caused by
improper installations.
7 to 9 mm
(1/4" to 3/8")
10 to 12 mm (3/8" to 1/2")
4 mm (#8)
20 mm (3/4")
or more
Spacer
Mounting holes
on bottom of
sound bar