User Manual
Table Of Contents
- CONTENTS
- INTRODUCTION
- BEFORE USING THE UNIT
- PREPARATION
- PLAYBACK
- CONFIGURATIONS
- Configuring various functions
- Changing the brightness of the indicators (Dimmer)
- Configuring the HDMI control function
- Configuring HDMI audio output
- Setting the auto power standby function
- Enabling/disabling touch panel control (Child Lock function)
- Enabling/disabling the network standby function
- Enabling/disabling the wireless (Wi-Fi) function
- Enabling/disabling the Bluetooth function
- Updating the unit’s firmware
- Selecting the HDMI signal format
- Initializing the unit
- Setting the dynamic range compression
- Configuring various functions
- APPENDIX
- When any problem occurs (General)
- When any problem occurs (Power and system function)
- The power turns off suddenly
- The power cannot be turned on
- No operations can be performed from the unit’s touch panel
- All indicators go out although the unit is turned on (it may seem that the unit is turned off)
- The unit does not function correctly
- The unit turns on by itself
- The TV’s 3D glasses do not work
- HDMI video is not displayed correctly on TV screen
- When the unit is turned off, video and/or audio from an AV device are not output to the TV
- The unit cannot be operated using the remote control
- The TV cannot be operated using the TV’s remote control
- The unit cannot be operated using the TV’s remote control
- Alexa will not operate the unit
- Alexa does not respond when summoned.
- When any problem occurs (Audio)
- When any problem occurs (Bluetooth®)
- When any problem occurs (Network trouble)
- Specifications
- Information for qualified contractors or dealers
Updating the unit’s firmware
New firmware that provides additional features or product
improvements will be released as needed. Firmware can be updated
using the Sound Bar Controller app installed on a mobile device.
n NOTICE
• Do not operate the unit or disconnect the power cord or network cable during
firmware update.
• If the Internet connection speed is slow, or the unit is connected to the wireless
network, network update may not be possible depending on the condition of the
network connection. Should this occur, try again at a later time.
• For details on update, visit the Yamaha website.
When a new firmware is released, a “NEW” icon is displayed on the
screen of the Sound Bar Controller app. Tap the icon, then follow the on-
screen instructions to update the firmware.
Selecting the HDMI signal format
Problems such as a lack of sound or the appearance of abnormal colors
in a video may occur when some AV devices are connected to the unit.
Should this occur, changing the setting may resolve these issues.
Mode 1 (default) Select this mode in most cases.
Mode 2
Select this mode if problems such as the appearance of
abnormal colors in video have occurred.
1
Turn on the unit.
2
Press STEREO for at least five seconds.
STEREO
Once the indicator has shown the setting applied to the unit
as follows, the unit will turn on.
Glows (mode 1)
Off (mode 2)
En
41