User Manual
Table Of Contents
- CONTENTS
- INTRODUCTION
- BEFORE USING THE UNIT
- PREPARATION
- PLAYBACK
- CONFIGURATIONS
- Configuring various functions
- Changing the brightness of the indicators (Dimmer)
- Configuring the HDMI control function
- Configuring HDMI audio output
- Setting the auto power standby function
- Enabling/disabling touch panel control (Child Lock function)
- Enabling/disabling the network standby function
- Enabling/disabling the wireless (Wi-Fi) function
- Enabling/disabling the Bluetooth function
- Updating the unit’s firmware
- Selecting the HDMI signal format
- Initializing the unit
- Setting the dynamic range compression
- Configuring various functions
- APPENDIX
- When any problem occurs (General)
- When any problem occurs (Power and system function)
- The power turns off suddenly
- The power cannot be turned on
- No operations can be performed from the unit’s touch panel
- All indicators go out although the unit is turned on (it may seem that the unit is turned off)
- The unit does not function correctly
- The unit turns on by itself
- The TV’s 3D glasses do not work
- HDMI video is not displayed correctly on TV screen
- When the unit is turned off, video and/or audio from an AV device are not output to the TV
- The unit cannot be operated using the remote control
- The TV cannot be operated using the TV’s remote control
- The unit cannot be operated using the TV’s remote control
- Alexa will not operate the unit
- Alexa does not respond when summoned.
- When any problem occurs (Audio)
- When any problem occurs (Bluetooth®)
- When any problem occurs (Network trouble)
- Specifications
- Information for qualified contractors or dealers
Initializing the unit
Reset the settings of the unit to the factory presets.
1
Turn off the unit.
2
Touch and hold } and z on the unit until all
indicators except the Alexa indicator flash.
Flash (initialized)
Setting the dynamic range compression
Select the dynamic range compression level.
This function is set to “No compression” by default.
1
Turn off the unit.
2
Use the remote control to select the desired
compression level.
Compresssion
level
Function
Operations (buttons must
be pressed consecutively
within three seconds.)
Compression
(maximum)
Apply the maximum amount
of dynamic range
compression.
STEREO, VOLUME (+), and
then z
Compression
(standard)
Apply the standard amount
of dynamic range
compression for normal
home use.
STEREO, VOLUME (-), and
then z
No compression
Dynamic range compression
is not applied.
STEREO, |, and then z
En
42