User Manual
Table Of Contents
- CONTENTS
- INTRODUCTION
- BEFORE USING THE UNIT
- PREPARATION
- PLAYBACK
- CONFIGURATIONS
- Configuring various functions
- Changing the brightness of the indicators (Dimmer)
- Configuring the HDMI control function
- Configuring HDMI audio output
- Setting the auto power standby function
- Enabling/disabling touch panel control (Child Lock function)
- Enabling/disabling the network standby function
- Enabling/disabling the wireless (Wi-Fi) function
- Enabling/disabling the Bluetooth function
- Updating the unit’s firmware
- Selecting the HDMI signal format
- Initializing the unit
- Setting the dynamic range compression
- Configuring various functions
- APPENDIX
- When any problem occurs (General)
- When any problem occurs (Power and system function)
- The power turns off suddenly
- The power cannot be turned on
- No operations can be performed from the unit’s touch panel
- All indicators go out although the unit is turned on (it may seem that the unit is turned off)
- The unit does not function correctly
- The unit turns on by itself
- The TV’s 3D glasses do not work
- HDMI video is not displayed correctly on TV screen
- When the unit is turned off, video and/or audio from an AV device are not output to the TV
- The unit cannot be operated using the remote control
- The TV cannot be operated using the TV’s remote control
- The unit cannot be operated using the TV’s remote control
- Alexa will not operate the unit
- Alexa does not respond when summoned.
- When any problem occurs (Audio)
- When any problem occurs (Bluetooth®)
- When any problem occurs (Network trouble)
- Specifications
- Information for qualified contractors or dealers
Information for qualified contractors or dealers
Mounting the unit on a wall
Mount the unit on a wall using the screw holes on the rear panel.
CAUTION
• Please have a qualified contractor or dealer when mounting the unit on a wall.
Some skills and experience are required for safe installation.
• To prevent the unit from falling, attach it to a wall constructed of drywall
(plasterboard).
• Make sure you use screws (sold separately) that can support the weight of the
installation. Using clamps other than specified screws, such as short screws, nails,
and two-sided tape, may cause the unit to fall.
• Fix the cables in place where they will not become loose. If your foot or hand
accidentally gets caught on a loose cable, the unit may fall.
• Do not lean on the unit or apply excessive force to the top of the unit. Doing so may
cause the unit to fall.
• Check that the unit is securely fixed after the installation. Yamaha will bear no
responsibility for any accidents caused by improper installations.
Remote control
sensor
Touch panel
1
Attach the mounting template (supplied) on a wall
and mark for the screw holes.
Tape or thumbtacks
Mounting template (supplied)
Screw holes
2
Remove the mounting template from the wall, and
then install screws (sold separately) at the points
marked on the wall.
7 to 9 mm
(1/4" to 3/8")
13 to 15 mm
(1/2" to 5/8")
4 to 5 mm
(#8 to #10)
20 mm (3/4") or
more
457 mm
(18")
En
56