User Manual

ManualsBrandsYamaha ManualsOtherATS-4080

This Guide provides instructions for updating firmware with a

USB flash drive on the following products.

• YAS-408

• ATS-4080*

• YMS-4080*

* Sold only in certain countries or regions

See product pages on the Yamaha website for details regarding

the issues resolved, and functions added, by updating firmware.

Equipment required for

firmware update

Prepare the following items before attempting to update firmware.

• USB flash drive

Use a USB flash drive that meets all of the following

requirements.

– Supports the USB mass storage device class

– Formatted in FAT16 or FAT32 format

– No encryption applied

– No data stored on the device (empty)

• Computer that can be connected to the Internet

Download the firmware from the Yamaha website.

Update Guide

Manual Development Group

Published 08/2018 NVOD-A0

AV17-0326

Summary of content (6 pages)

PAGE 1
EN Manual Development Group © 2018 Yamaha Corporation Published 08/2018 NVOD-A0 AV17-0326 Update Guide Equipment required for firmware update This Guide provides instructions for updating firmware with a USB flash drive on the following products. • YAS-408 • ATS-4080* Prepare the following items before attempting to update firmware. • YMS-4080* * Sold only in certain countries or regions • USB flash drive Use a USB flash drive that meets all of the following requirements.
PAGE 2
Preparing the firmware 1 2 Download the latest version of firmware from the Yamaha website to a computer. See product pages on the Yamaha website for more information. Decompress the downloaded file and save the firmware data file to the USB flash drive. Be sure to save the firmware data file in the top folder (root folder) of the USB flash drive. Do not change the file name when saving it. File names are as follows: • YAS-408: 000450-xxxx.bin • ATS-4080: 000652-xxxx.bin • YMS-4080: 000451-xxxx.
PAGE 3
Updating the unit’s firmware 1 Turn off the unit. 2 Unplug the power cable from the AC wall outlet. 3 Connect the USB flash drive to the UPDATE ONLY jack on the unit. 5 Touch and hold least 3 seconds. and together for at The firmware update begins. The indicators will glow as shown below while the firmware is being updated. YAS-408 ATS-4080 YMS-4080 Running display (glow in succession) Glows The indicators will flash as shown below when the firmware update has been successfully completed.
PAGE 4
NOTICE Do not unplug the power cable or disconnect the USB flash drive until the following procedures are completed. 6 Touch when the firmware update is complete. The unit will turn off. 7 Disconnect the USB flash drive. The firmware update has been completed.
PAGE 5
Troubleshooting If the firmware update fails, the indicators will flash as illustrated below. Confirm the problem and try updating the firmware again. Flashing (red) indicator Flashes (red) Cause Remedy Cause Remedy The USB flash drive is not connected to the unit correctly. 1. Terminate the update by touching z. 2. Connect the USB flash drive to the unit correctly. 3. Try updating the firmware again. The firmware data file was not properly saved to the USB flash drive. 1.
PAGE 6
Indicators off Turned off Cause Remedy The USB flash drive was disconnected from the unit while firmware was being updated. 1. Terminate the update by touching z. 2. Connect the USB flash drive to the unit correctly. 3. Try updating the firmware again. The USB flash drive is damaged. 1. Terminate the update by touching z. 2. Save the firmware data file to another USB flash drive and try updating the firmware again. There is a problem with the firmware data file. 1.