User Manual

8
1. As shown in the illustration, remove the base attachment wing bolts q, and use them to attach the base w to the main
body e. Do not fully tighten the wing bolts in this step.
If damage to the floor is not a concern, connect the spurs r to the base so that the tip of the spurs dig into
the riser or floor. To prevent damage to the floor, retract the spurs r, place a mat or carpet under the KP90
and use the Velcro™ strip t, attached to the underside of the KP90’s base to prevent the KP90 from moving
during performance.
2. Attach your foot pedal to the KP90. Adjust the base’s position so that the pad surface of the KP90 is vertical when the
foot pedal is attached, and the KP90 is stable when the beater hits the pad. After the position is determined, firmly
tighten the wing bolts q to secure.
3. Adjust the position of the pedal and the length of the beater shaft so that the foot pedal’s beater y hits in the center of
the kick pad u.
The KP90 can be used with a double foot pedal (YAMAHA DFP series, etc). When using a double foot pedal,
please adjust the position of the pedal and the length of the beater y so that the space between the two
beaters is positioned in the center of the pad. [Fig. A]
Assembling the KP90
q
e
w
e
u
y
q
t
r
1
23
w
y
u
Figure A