User Manual

17
DTX-PRO Owner’s Manual
Turning On or Off
Setup Guide
 Turning On
1.
Turn the [MASTER VOLUME] knob fully
counterclockwise to lower the DTX-PRO vol-
ume to its minimum.
2.
Press the [ ] (Standby/On) switch.
If the initial setup is already complete, the KIT screen
appears directly after the startup screen, without showing
the Trigger Setup Wizard.
3.
If you are connected to a PA system:
Turn the external speakers on.
Turning On or Off
Initial Setup (Trigger Setup Wizard)
When you turn on your DTX-PRO for the first time, the Initial Setup page will be displayed. On this page, you
will be required to specify the following. When you specify the model number, the DTX-PRO will automatically
optimize the trigger output levels for all of your pads.
1. Identify your drum kit using the [–][+] controllers and press the button below “OK”
([F3]).
2. When the confirmation screen appears, press the button below “YES” ([F1]).
When the initial setting is complete, the KIT screen appears.
NOTE
• Your drum kit’s model number is indicated on the Assembly Manual for your drum kit.
• You can change the specified drum kit at any time after completing Initial Setup. For more information, refer to the
Reference Manual (PDF). (MENU/Job/Trigger)
* XSTICK: May not be shown depending
on the pad
Power on