User Manual

TIPS!
22
DTX900
 Adjusting the Noise Filter
Follow the steps below to make adjustments in situations where, for whatever reason, noise enters the trigger signal when
a pad is struck or other instability in trigger signals leads to sounds not being generated correctly.
1. Press the [TRIGGER] button to access Trigger mode.
2. Press the [F3] button to call up the Trigger Sensitivity Settings display.
3. Select the name of the jack (q) used for connection to the drum trigger module, and then adjust the NoiseFilter
parameter (w).
4. Store your settings on the drum trigger module as a User Trigger to ensure they are not lost. Refer to “2-2. Storing Pad
Types” in this manual for details on how to store settings.
 Adjusting Head and Rim Balance
Follow the steps below to adjust the balance between the head and rim of the snare or other drum on which a DT50S is
mounted.
This setting will only work when you have selected “DT50S (for snare)”, “DT50S (for HiTom)”, or “DT50S (for LoTom)”
for the PadType parameter.
1. Press the [TRIGGER] button to access Trigger mode.
2. Press the [F2] button to open the PadType parameter page.
3. Select the name of the jack (q) used for connection to the drum trigger module, and then adjust the balance (w).
4. Store your settings on the drum trigger module as a User Trigger to ensure they are not lost. Refer to “2-2. Storing Pad
Types” in this manual for details on how to store settings.
q
w
HINT
The larger the value, the more noise and unintentional sounds will be filtered. Larger noise filter settings can, in cases where the
drum is struck multiple times in rapid succession, result in sounds being dropped. Be sure to adjust the setting to best match your
style of drumming.
q
w
HINT
If the head sounds when the rim is struck, move the balance further to the R side (i.e., raise the setting) to ensure that the rim
sounds. Similarly, if the rim sounds when the head is struck, move the balance further to the H side (i.e., lower the setting) to
ensure that the head sounds instead. Adjust the value until you reach the optimal balance.