Owner`s manual

5
Before you begin
Operation section
Installation procedure
Please carefully read the cautions for installing
optional equipment given at the beginning of this
manual.
1
You will need the following items.
• The AW2816 itself
• Internal CD-RW drive (option)
• Four screws (included with the AW2816) for
attaching the CD-RW drive
• Philips (+) screwdriver
• Work surface
• In order to install the CD-RW drive you will need to
turn the AW2816 on its back. Make sure that you
have a sufficiently broad work surface.
• The AW2816 is shipped with four screws for attach-
ing the 2.5 inch hard disk, and four screws for
attaching the CD-RW drive, making a total of eight
screws of the same type.
2
Make sure that the power of the AW2816
is turned off. For safety’s sake, disconnect
the power cable from the AC outlet.
Always switch off the power for the main unit and all
peripherals, unplug the power cord for the main unit
from the outlet, then disconnect the cables connect-
ing the main unit with the peripherals before starting
installation work.
3
Spread a soft cloth over your work surface,
and place magazines or books to support
the four corners of the AW2816 so that the
faders, keys, and other controllers on the
top panel will not be damaged. Then turn
the AW2816 face down.
4
Remove the CD-RW drive cover from the
front panel, and remove the bottom panel.
5
Turn the CD-RW drive over, and insert it lit-
tle by little, stopping when the connector
end of the CD-RW drive enters the opening
in the bottom of the AW2816.
6
Connect the flat cable (1) and CD-RW
drive power supply connector (
2) (from
inside the AW2816) to the connectors of
the CD-RW drive. Connect the flat cable
first, and then the power supply connector.
Bottom panel
CD-R/RW drive
cover panel
Power supply
connector
Flat cable