Owner`s manual

UTILITY screen
264
Reference section
Prefer.1 page
Make overall settings for the AW2816 (1)
Function
Enable/disable warning messages, and
specify the point from which direct out-
put will be taken.
Key operation
• [UTILITY] key → [F2] (Prefer.1) key
• Repeatedly press the [UTILITY] key
until the screen shown at the right
appears.
Screen functions
A AUTO SCENE NAME DISPLAY
If this button is on, operating any of the keys in the
SCENE MEMORY section ([STORE] key, [ ]/[ ]
keys, etc.) will cause the scene name to be dis-
played for a time in the upper right of the screen
(Default setting= on).
B SCENE NAME DISPLAY TIME
This setting specifies the length of time that the
scene name will be displayed when the AUTO
SCENE NAME DISPLAY button (1) is on. This can
be set in one-second increments over a range of 1
to 9 seconds (Default setting= 4 seconds).
C STORE CONFIRMATION
If this button is on, a popup window will ask you
for confirmation when you store a scene or library
(Default setting = on).
D RECALL CONFIRMATION
If this button is on, a popup window will ask you
for confirmation when you recall a scene or library
(Default setting = on). You can turn this off if you
want to switch scenes quickly.
E DIRECT OUT EXTRACT POSITION
Use the following three buttons to select the loca-
tion from which the signal will be sent when you
use direct output from input channels 1–8.
• PRE EQ................ Before the EQ
• PRE FADER.......... Before the fader
• POST FADER ....... After the fader (default set-
ting)
Input c
hannel
5
6
7
1
2
3
4
ATT
4BAND EQ
DYNAMICS
etc.
PAN
LEVELON
PRE FADER
POST FADER
PRE EQ
DIRECT OUT
INPUT SELECT