Owner`s manual

303
Reference section
DYN/DLY screen
D ON/OFF
This button turns the dynamics processor on/off.
Tip!
Even when the cursor is in the PARAMETER area ( 9 ),
you can press the [ENTER] key to turn this button on/
off.
E GR (Gain reduction)
This displays the amount of gain reduction produced
by the dynamics processor, in a range of –18 dB–
0 dB
.
F Output meter
This indicates the signal level after passing through
the dynamics processor.
G CURVE
This shows the approximate response of the cur-
rent dynamics processor. The horizontal axis of the
graph is the input level, and the vertical axis is the
output level.
H TYPE
This shows the type of the currently selected
dynamics processor. The display has the following
meaning.
• COMP ................. Compressor
• EXPAND.............. Expander
• GATE................... Gate
• COMPANDER (HARD/SOFT)
Compander (hard/soft)
• DUCKING........... Ducking
It is not possible to change the type of dynamics pro-
cessor in this page. If you want to use a different type,
settings that use the desired type must be recalled
from the library. (Recall operations are performed in
the DYN/DLY screen/Library page.)
I PARAMETER
Here you can set the various parameters of the
dynamics processor. The type and range of the
parameters will differ depending on the type of
dynamics processor. For details on the type and
function of the parameters, refer to the appendix at
the end of this manual.