Owner`s manual

395
Appendix
Appendix
Messages at power-on
No Song to Backup!
There is no song to backup.
No Song to Edit!
There is no song has been selected for editing.
No Song to Load!
There is no song to load.
No Song to Restore!
There is no song to restore.
No Song to Save!
There is no song to save.
No Song to Write!
No songs to write to the CD have been selected.
No Song!
No songs can be found.
No Stereo Track!
There is no stereo track.
No Track to Open Wave Display!
There is no track data for waveform display.
Not WAV Drive!
The selected drive contains no WAV files.
Not WAV File!
The file is not a WAV file.
Partition Not Found!
The specified partition was not found.
Recall Channel Data Conflict!
The specified channel library cannot be loaded into this channel.
SCSI Error!
An error has occurred in the SCSI connection.
Selected Drive is not CD Drive!
The selected drive is not a CD drive.
Selected Drive is not Connected!
The selected drive is not connected.
Selected Preset is Effect2 Only!
The selected preset can be used only by effect 2.
Selected Song Status Conflict!
The track cannot be imported, since it is from a song with a different
sampling frequency or quantization (bit length).
Selected Track is not Recorded!
The selected track is not recorded.
Too Many Regions!
There are too many regions.
Too Small Region!
Time compression/expansion cannot be executed since the region is
too small.
Unformatted HDD
The internal hard disk has not been formatted for the AW2816. This
message will be displayed if a new hard disk is installed.
Recognized AW4416-Formatted HDD
A hard disk formatted for the AW4416 is installed.
Can not find HDD
No internal hard disk is installed, and the AW2816 cannot start up
correctly.
Illegal HDD!
A problem was found with the internal hard disk, and the AW2816
cannot start up correctly.
Format OK? [Y (Enter) /N (Any)]
If you want to format the internal hard disk for the AW2816, press the
[ENTER] key. If you want to exchange the internal hard disk without
formatting it for the AW2816, make sure that the access indicator is
dark, and turn off the power.