Owner`s manual

413
Appendix
Appendix
function number channel Tx/Rx
-----------------------+------------------------+---------+---------
0x00 scene recall 0-96(memory 0-96) 0x00 Tx* /Rx
0x01 eq lib recall 0-127(library 1-128) 0-26 Tx/Rx
0x02 dyn lib recall 0-127(library 1-128) 0-23,26 Tx/Rx
0x03 eff lib recall 0-127(library 1-128) 24,25 Tx/Rx
0x04 ch lib recall 0-64(library 0-64) 0-26 Tx/Rx
0x05 patch lib recall 0-20(library 0-20) 0 Tx/Rx
0x10 scene store 1-96(memory 1-99) 0x00 Rx only
0x11 eq lib store 40-127(library 41-128) 0-26 Rx only
0x12 dyn lib store 40-127(library 41-128) 0-23,26 Rx only
0x13 eff lib store 41-127(library 42-128) 24,25 Rx only
0x13 ch lib store 2-64(library 2-64) 0-26 Rx only
0x13 patch lib store 1-20(library 1-20) 0 Rx only
Channel 0-7(INPUT 1-8), 8-23(MONITOR 1-16), 24,25(RTN 1-2/EFF 1-2), 26(st mas)
* [0x00: scene recall] is transmitted only when you recall
a program that has not been assigned in the [Program
change table]. Normally a program change will be trans-
mitted.
4.13.3.9 Parameter Change (type 0x43:control-
ler(key remote))
< Reception >
This message is received if [Parameter Change RX] is ON
and the [Rx CH] matches the MIDI channel included in
the Sub Status.
This message will be echoed if [Parameter Change
ECHO] is ON.
When this message is received, the same processing will
be performed as when the specified key (see table below)
is pressed (released)
< Transmission >
This message will be echoed if [Parameter Change
ECHO] is ON.
STATUS 11110000 F0 System Exclusive Message
ID No. 01000011 43 Manufacturer's ID
No.(YAMAHA)
SUB STATUS 0001nnnn 1n parameter change n=0-
15(MIDI Channel No.1-16)
GROUOP ID 00111110 3e MODEL ID(digital mixer)
MODEL ID 00000111 07 Device code (AW2816)
PARAM TYPE 01000011 43 controller
DATA 00000000 00 control no.(0:key remote)
0ddddddd dd No. 0-13(key 1-14)
0000dddd dd data(bit0-2:change bit
no.0-7, bit3:0=reset
1=set)
: :
EOX 11110111 F7 End Of Exclusive
KEY
key no. rx/tx bit0 bit1 bit2 bit3 bit4 bit5 bit6 bit7
------+-----+-----+---------+---------+---------+---------+---------+---------+---------+---------
key1 0 rx SONG PATCH AUX3 MON9-16 CTRL SEL7 ON3 ONRTN1
key2 1 rx CUE REC6 REC13 AUTOMIX REDO NUM SET END
key3 2 rx FILE VIEW AUX4 SHIFT SEL1 SEL8 ON4 ONRTN2
key4 3 rx METER REC7 REC14 SCENE JOGON MARK< REPEAT CANCEL
key5 4 rx CD PAN AUX5 F1 SEL2 SELST ON5 SOLO
key6 5 rx REC1 REC8 REC15 STORE UP MAEK> A REW
key7 6 rx QUICK EQ AUX6 F2 SEL8 RELRTN1 ON6 REMOTE
key8 7 rx REC2 REC9 REC16 SCENE- DOWN MARK B FF
key9 8 rx SETUP DYN HOME F3 SEL4 SELRTN2 ON7 SAFE
key10 9 rx REC3 REC10 RECST SCENE+ LEFT PUNCH ROLL STOP
key11 10 rx UTILITY AUX1 INPUT F4 SEL5 ON1 ON8 --------
key12 11 rx REC4 REC11 TRACK RECALL RIGHT IN TOP PLAY
key13 12 rx MIDI AUX2 MONI1-8 F5 SEL6 ON2 ONST FOOT SW
key14 13 rx REC5 REC12 EDIT UNDO ENTER OUT RTZ REC
You must transmit Reset (bit 3=0) after transmitting Set
(bit 3=1).