Owner`s manual

53
Let’s record on the AW2816
3
Operation section
2
Press the INPUT [1-8] key → [SEL] key 8.
On the AW2816, you specify the channel that
you want to operate by first selecting the mixing
layer in the MIXING LAYER section, and then
using a [SEL] key to select the desired channel.
(The [SEL] key of the selected channel will light.)
In the CH View page, the currently selected
channel is shown in the upper left of the display.
3
Move the cursor to the ST button in the
PAN/ROUT area, and press the [ENTER] key
to switch it off.
Now the input signal of input channel 8 will no
longer be sent to the stereo bus.
4
Press the [PATCH] key → [F1] key.
The PATCH screen Patch IN page will appear.
5
Move the cursor to the RECORDER TRACK
INPUT ASSIGN area, and change the set-
ting of recorder input 3 to “DIR 8.”
Now the input signal of input channel 8 (bass)
will be sent directly to track 3.
6
Press the REC TRACK SELECT [3] key.
The REC TRACK SELECT [3] key will begin blink-
ing, and track 3 will be in record-ready mode.
7
Press the [METER] key.
The METER screen will appear. In the INPUT
MONITOR area, make sure that the AUTO but-
ton is turned on.
8
While playing the bass connected to INPUT
(HI-Z) jack 8, watch level meter 3.
The level of the signal sent to the input of track 3
will be displayed in level meter 3. If the level
meter reaches the OVER position, check whether
fader 8 (input level of input channel 8) is set
appropriately.