Owner`s manual

Let’s record on the AW2816
56
Chapter
3
Operation section
4
Move the cursor to the RECALL button at
the left of the library list, and press the
[ENTER] key.
A CONFIRMATION popup window will appear,
asking you whether you really want to recall the
data.
5
Move the cursor to the OK button and
press the [ENTER] key.
The “E.B. Finger” program will be loaded into the
dynamics processor of input channel 8.
6
Press the [F1] key.
The DYN/DLY screen Dyn.Edit page will appear.
In this page you can edit the parameters of the
dynamics processor.
7
Press the [ENTER] key to turn on the ON/
OFF button located in the lower left of the
display.
The ON/OFF button switches the dynamics pro-
cessor on/off. This enables the dynamics proces-
sor of input channel 8.
Tip!
In the Dyn.Edit page, you can press the [ENTER] key
to switch the ON/OFF button regardless of the loca-
tion of the cursor.
8
While playing your instrument, edit the
dynamics processor parameters as desired.
To adjust the parameters, move the cursor to the
PARAMETER area in the lower right of the dis-
play, and use the [DATA/JOG] dial to edit the
value.
The upper right of the display contains a meter that
indicates the signal level after passing through the
dynamics processor. Be careful that this meter does
not reach the “OVER” level.
Tip!
• The dynamics processor provides five types: CMP
(compressor), EXP (expander), GAT (gate), CPS
(compander soft), and CPH (compander hard). Each
of these types has different parameters. (refer to
page 382 for the parameters of each type.)
• In the Dyn.Edit page, it is not possible to switch the
dynamics processor type. If you want to use a spe-
cific type, you must start by loading a dynamics
library program that uses that type, and then edit
the parameters as desired.