User Guide

Input/output patching
72
Chapter
4
Operation section
2
Move the cursor to the channel whose
patching you want to change, and use the
[DATA/JOG] dial to select the desired sig-
nal.
The following signals can be assigned to each
channel.
• Input channels 1–8
• Return channels 1/2
For example if you change input channel 2 to
“AD 1” (INPUT jack 1) from the default setting,
the input signal of INPUT jack 1 will be sent to
both input channels 1 and 2, as shown in the dia-
gram below.
Tip!
• You can use the patch library to save the edited
patching status. For details refer to page 76.
• Return channels 1/2 can also be used as input chan-
nels.
Display Signal type
AD 1–AD 8 INPUT jacks 1–8
SLT-1–SLT-8 INPUT 1–8 of an I/O card
DIN L/DIN R
L or R channel of the DIGITAL
STEREO INPUT jack
MET Internal metronome
Display Signal type
EFF1 L/R Return from internal effect 1
(*1)
*1. Only return 1 can be selected
EFF2 L/R Return from internal effect 2
(*2)
*2. Only return 2 can be selected
AD 1/2–AD 7/8 INPUT jacks 1/2–7/8
SLT-1/2–SLT-7/8 INPUT 1/2–7/8 of an I/O card
DIN L/R
DIGITAL STEREO INPUT jack
(stereo)
Input channel 1
Input channel 2
Input channel 3
Mixer section
1 (AD 1)
INPUT
jacks
2 (AD 2)
3 (AD 3)
8 (AD 8)
Input channel 8
INPUT patch