User Guide

Input/output patching
74
Chapter
4
Operation section
Assigning signals to output jacks/
output channels (Output Patch)
In the Output Patch section, signals such as buses 1–8,
AUX buses 1–6, the stereo bus, and direct outputs
from the recorder can be assigned to output jacks
such as the STEREO OUT jacks and OMNI OUT jacks
1–4, or output channels of the OPTION I/O slot.
With the default settings of the AW2816, the follow-
ing signals are assigned to the various output jacks
and output channels.
To change the patching shown above, use the follow-
ing procedure.
1
Press the [PATCH] key → [F2] (Patch OUT)
key.
The PATCH screen Patch OUT page will appear.
The various areas of the display show the patch-
ing status for each input jack.
A OMNI OUT jacks 1–4
B DIGITAL STEREO OUT jack
C STEREO OUT jacks
D Output channels 1–8 of an I/O card (OPTION
I/O slot)
2
Move the cursor to the output jack whose
patching you want to change, and use the
[DATA/JOG] dial to select the signal that
you want to assign.
The following types of signals can be assigned to
each output jack.
• OMNI OUT jacks 1–4
AUX buses 1–4
AUX buses 5/6
Buses 1–8
Stereo output channel
Mixer section
Recorder section
Output
Patch
×4
×8
×2
×16
×8
×30
×2
OMNI OUT jacks 1–4
DIGITAL STEREO OUT jack
STEREO OUT jacks
I/O card
OPTION I/O
slot
Channel insert send
Direct output of
input channels 1–8
Direct output of tracks 1–16
2
3
4
1
Display Signal type
ST L/ST R L/R stereo output channels
BUS 1–BUS 8 Buses 1–8
DIR 1–DIR 8
Direct output of input chan-
nels 1–8
AUX 1–AUX 6 AUX buses 1–6
RDR 1–RDR 16 Direct output of tracks 1–16