Specifications

- 31 -
Changing the Output Routing
It is possible to route each bus or send (except Aux 5-6) to any output or any com-
bination of outputs. However, it is not possible to route several different buses to
the same output. Output routing is done in the Output Patchbay window:
1. Open the Output Patchbay window.
2. Locate the output you want to access, in the list to the left.
Note that the outputs listed are outputs pairs. The “DS2416” output pairs are connected to
the Cubase VST Inputs, while the “IOA” and “IOB” output pairs are outputs on additional i/o
units, connected as unit A and B, respectively.
3. Pull down the pop-up menu next to the output and select the desired Aux or Bus Send
pair.
❐ Even though the Aux Sends are selected in pairs, it is not possible to use them as “ste-
reo sends”, since the pan setting of the channel is not taken into account. If you need
stereo sends (for external stereo input effects or stereo monitoring), use the Bus sends
in Post Pan mode.