Specifications

- 7 -
Activating and Assigning Output Buses
1. Pull down the Panels menu and select VST Master Mixer.
The VST Master window appears. In a single DS2416 card configuration, there are eight
buses including the Master bus.
2. Activate all buses by clicking on their Active buttons.
3. Pull down the pop-up menus at the bottom of each Bus channel strip and check that
each bus is assigned to the desired DS2416 output.
To avoid confusion, we recommend that you keep the default order of the outputs, so that
the Master bus is connected to the PCI #1/2 output, the second Bus is connected to the PCI
#3/4 output, and so on.
❐ These PCI outputs are not the physical outputs of the audio hardware, but rather “out-
put lines” connecting VST to the DS2416. The actual routing to physical outputs is
done in the DSP Factory windows, as described on page 31.
4. If you like, rename the buses by clicking in their name fields (above the Active buttons)
and typing in new names.
These names will be shown on the Output pop-up menus in VST.
5. Click in the close box to close the Master window.