User Manual

Page 3 of 4 Yamaha BD-S2900 Firmware Update
4. PRECAUTIONS –before you start the update
FOLLOW INSTRUCTIONS CAREFULLY.
 Firmware update may take approximately 5 minutes.
 Do NOT press any buttons on the front panel or the remote controller while update
is in progress. Firmware may not be installed properly.
 Do NOT power off or unplug the AC power cable while update is in progress.
Worst case the BD-S2900 may not recover.
5. Installing firmware to BD-S2900
STEP1. Connect power cable to the AC outlet.
STEP2. Turn on the unit by pressing the [STANDBY/ON] button.
STEP3. Open the disc tray by pressing the [OPEN/CLOSE] button.
STEP4. Set the update disc on the disc tray and close the disc tray by pressing the
[OPEN/CLOSE] button.
Note
When “NoUPDATE” scrolls across and “STOP” appears on the front display, the
firmware version in your BD-S2900 is the same as or higher than the version in the
update disc. In this case, update is unnecessary. Remove update disc from the disc
tray.
STANDBY/ON
OPEN/CLOSE