User's Manual
4 - 104
ENG
TRANSMISSION, SHIFT CAM AND SHIFT FORK
2. Install:
• 2nd wheel gear (28T) 1
• 4th wheel gear (25T) 2
• 3rd wheel gear (28T) 3
• 5th wheel gear (22T) 4
• 1st wheel gear (31T) 5
• O-ring 6
To drive axle 7.
N
OTE:
• Apply the molybdenum disulfide oil on the
1st, 2nd and 3rd wheel gears inner circum-
ference and on the end surface.
• Apply the molybdenum disulfide oil on the
4th and 5th wheel gears inner circumference.
• Apply the lithium soap base grease on the O-
ring.
New
3. Install:
• Washer 1
• Circlip 2
N
OTE:
• Be sure the circlip sharp-edged corner a is
positioned opposite side to the washer and
gear b.
• Be sure the circlip end c is positioned at
axle spline groove d.
New
4. Install:
• Collar 1
N
OTE:
• Apply the lithium soap base grease on the oil
seal lip.
• When installing the collar into the crankcase,
pay careful attention to the crankcase oil seal
lip.