User's Manual
4 - 16
ENG
CARBURETOR
8. Install:
● Throttle shaft assembly 1
● Plain washer (metal) 2
● Plain washer (resin) 3
● Valve lever 4
NOTE:
● Apply the fluorochemical grease on the bear-
ings.
● Fit the projection a on the throttle shaft
assembly into the slot b in the TPS (throttle
position sensor).
● Make sure the stopper c of the spring fits
into the recess in the carburetor.
● Turn the throttle shaft assembly left while
holding down the lever 1 5 and fit the throt-
tle stop screw tip d to the stopper e of the
throttle shaft assembly pulley.
1
2
3
4
b
a
c
e
d
5
9. Install:
● Push rod 1
NOTE:
While holding down the lever 1 2, insert the
push rod farthest into the carburetor.
1
2
10. Install:
● Starter jet 1
● Pilot jet 2
● Spacer 3
● Needle jet 4
● Main jet 5