Owner's Manual

8-11

3. Install the spark plug with the spark plug

wrench, and then tighten it to the specified

torque.

NOTE:

If a torque wrench is not available when installing

a spark plug, a good estimate of the correct torque

is 1/4–1/2 turn past finger tight. However, the spark

plug should be tightened to the specified torque as

soon as possible.

4. Install the spark plug cap.

EBU23276

Engine oil and oil filter element

The engine oil level should be checked before

each ride. In addition, the oil must be changed and

the oil filter element cleaned at the intervals speci-

and lubrication

chart.

To check the engine oil level

1. Place the ATV on a level surface.

2. Check the engine oil level on a cold engine.

NOTE:

If the engine was started before checking the oil

level, be sure to warm up the engine sufficiently,

and then wait at least ten minutes until the oil set-

tles for an accurate reading.

3. Remove the engine oil filler cap, and then

wipe the dipstick off with a clean rag.

4. Insert the dipstick into the filler hole (without

screwing it in), and then remove it again to

check the oil level.

Tightening torque:

Spark plug:

17.5 Nm (1.75 m·kgf, 12.7 ft·lbf)

1. Engine oil filler cap

U4S110E0.book Page 11 Friday, August 4, 2006 4:03 PM