Owner's Manual

8-13

CAUTION:

ECB00310

When removing the engine oil drain bolt, the

compression spring, oil strainer and O-ring will

fall out. Take care not to lose these parts.

NOTE:

Skip steps 5–9 if the oil filter element is not being

cleaned.

5. Remove the oil filter element cover by remov-

ing the bolts, and then remove the oil filter el-

ement.

6. Clean the oil strainer and oil filter element with

solvent.

7. Check the O-rings for damage and replace it if

necessary.

8. Install the oil filter element and O-ring.

NOTE:

Make sure that the O-ring is properly seated.

9. Install the oil filter element cover by installing

the bolts, and then tighten them to the speci-

fied torque.

1. Oil filter element cover

2. Bolt

1. O-ring

2. Oil filter element

U4S110E0.book Page 13 Friday, August 4, 2006 4:03 PM