Service manual

C,.BO.ETO.IC'"B0IID'I'I C,.BO.ETO.IOA"B01
3. Install:
NOTE: _ • Carburetor
The float arm should be resting on the needle NOTE:
valve. It should not compress the needle valve. Align projection (D with projection (_).
If the float height is not within specification,
inspect the needle valve, float and valve
seat.
If one of these parts is worn, replace the
whole set. _"_ _ INSTALLATION
If both parts are in good condition, replace To installthe carburetorreversethe"REMOVAL"
the float. (T_ _ procedures. Note the following points.
.... Check:he**float.height.aga_n.................. 1. Install:
• Carburetor cover O
NOTE: •Airhose(_)
The float height is factory-adjusted. Never try to Pass the air hose through the hole _ in the
adjust it yourself, carburetor cover.
ASSEMBLY 2.Adjust:
Reversethe"DISASSEMBLY" procedures. Note • Throttle cable free play
Refer to 'q'HROTTLE CABLE FREE PLAY AD-
the following points. JUSTMENT" in CHAPTER 3.
o Before reassembling the carburetor wash
all its components in clean gasoline.
• Always use new gaskets.
(_ 1. Install: _ 3. Install:
(_ I_ • Needle _ • Air filter case assembly
_ •Clip(_)
• Throttle valve (i)
• Spring seat (_)
• Spring
_ Jet needleclip position:
3_o_8 315
2. Install:
• Throttle valve (D
• Starter plunger
NOTE:
Align the groove (_)of the throttle valve with the
projection (_) of the carburetor body.
3_3019
5-5 5-6