Service manual

.O.TB,,KEIC"'S 1E-81 F.O.TB.,KIC"'S
_ 4. Remove: _ 3. Check:
o Master cylinder dust boot 0 , Brake hose (_)
• Master cylinder kit (_) CrackslWearlDamage .._Replace.
34700e 34e014
INSPECTION AND REPAIR /_._ \ 4. Measure:
Recommended brake component replacement _ • Brake disc deflection
schedule: Out of specification _ Inspect wheel runout.
If wheel runout is good, replace the brake
Brake pads As required disc.
Piston seal,
Dust seal Every two years _1 Brake Disc Maximum Deflection: I
Brake hoses Every four years F_,] 0.25 mm (0.01 in)
I
3470O1
Brake fluid Replace only when - Brake disc thickness
brakes aredisassembled _[ _ _ I _)lOutof specification ---,Replace. I
_ Brake Disc Minimum Thickness: I
_1W_'1;10117_[¢]1 3 mm (0.12 in)
All internal parts should be cleaned in new
brakefluidonly.Donotusesolventsasthey _ Bolt(brakedisc):
will cause seals to swell and distort. 23 Nm (2.3 m.kg, 17 ft.lb)
LOCTITE ®
1. Inspect : CALIPER ASSEMBLY
• Caliper piston C)
__ _ Scratches/Rust/Wear _ Replace caliper _'y11'i,L,1;l_ll_[¢!
• assembly. • All internal parts should be cleaned in new
• Caliper body _) brake fluid only.
Wear/Scratches/Cracks/Damage_Reptace • Internal parts should be lubricated with
caliper assembly, clean brake fluid when installed.
I
3,7oo_ Replacethe piston sealswheneverthecaliper DOT #3 or DOT #4
is disassembled.
_ 2. Inspect: __ , Replace the piston seals whenever a caliper
• Master cylinder is disassembled.
Wear/Scratches -_ Replace the master 1. Install:
cylinder assembly. • Piston seals (_
° Master cylinder body/Diaphragm • Caliper piston (_)
Cracks/Damage _ Replace. _'!_I'A'/-'I;I_IR[¢_
• Master cylinder kit Always use new piston seals.
3470o6 Scratches/Wear/Damage--* Replace asa set. 346ols
6-9 6-10