User Manual

Dante Firmware Update Manager User Guide
Version 2.7 Commercial in Confidence Page 11 of 21
5.4. Selecting an interface
If you have multiple network interfaces enabled on your computer, when you first start Dante Firmware
Update Manager you will be prompted to choose a Dante network interface for the upgrade (as shown
below).
Select the interface used for the primary Dante network, then click Next.
If you have Dante Controller or Dante Virtual Soundcard installed, Firmware Update Manager will
automatically preselect the primary interface that was last used by either of those applications.
If Dante Virtual Soundcard is running, you will not be able to change the primary interface in Firmware
Update Manager, unless you first stop Dante Virtual Soundcard.
Note: If you do not have a secondary (redundant) network, the network interface will be
automatically selected. Just click Next to continue.
5.5. Selecting a mode
The Firmware Update Manager has two modes of operation:
1. Update Dante Firmware
2. Failsafe Recovery
In most cases, you will require 'Update Dante Firmware' mode. This is the mode to use to update Dante
modules with new firmware versions.