User Manual
Table Of Contents
- Copyright
- About Audinate
- Introduction
- Installing Dante Controller
- Dante Basics
- Discovery and auto-configuration
- Device Channels
- Differentiating between input and output channels
- Device Names and Channel Labels
- Routing Audio
- Clock Synchronization
- Latency
- Device Lock
- Dante Control and Monitoring
- Starting Dante Controller
- Using Dante Controller
- Network View
- Status Bar
- Network View Tabs
- Channel Groups
- Clock Status Monitoring
- Clock Status Monitor
- Automatic Notification of Device Errors
- Device View
- Device View Tabs
- Multicast Transmit Flow Configuration
- Using Dante Controller with Dante Domain Manager
- Presets
- Troubleshooting
- Fanout
- Messages on Startup
- Computer Configuration Checklist
- Troubleshooting Dante IP Address Configuration
- Troubleshooting Switch Configuration and Cabling
- Index
Dante Controller User Guide
Copyright © 2018 Audinate Pty Ltd. All rights reserved.
-65-
Device View Tabs
The Device View is split into tabs, some of which are only applicable to certain devices. Each tab is
described in detail below.
Receive Tab
The Receive tab displays a list of all subscribed and dormant receive channels on the current device, plus
subscription information for the subscribed channels. It also allows the creation of subscriptions from the
Available Channels list.
The tab is split into two panes: Receive Channels, and Available Channels.
Receive Channels
The Receive Channels pane contains four fields:
n Channel: Lists the receive channel labels for the current device. These can be edited here to rename
the channel.
n
Signal: Supported devices will also show the following channel metering icons, indicating the
presence of audio on subscribed channels:
Channel is either muted, or receiving audio at less than -61dbFS