User Guide

8 9
PITCH/FILTER
MODEL BASED ON*
Bass Octaver EBS
®
OctaBass
Growler Synth Line 6 Original
Pitch Harmony Line 6 Original
Pitch Shift Line 6 Original
Tycoctavia Fuzz Tycobrahe
®
Octavia
Synth String Line 6 Original
*All product names used in this document are trademarks of their respective owners
and neither Yamaha Guitar Group nor Line 6 are associated or aliated with them.
These trademarks appear solely to identify products whose tones and sounds were
studied by Line 6 during sound model development.
EBS is a registered trademark according of EBS Holding. Fender is a registered
trademark of Fender Musical Instruments Corp. Leslie is a registered trademark of
Suzuki Musical Instrument Manufacturing Co. Ltd. Maestro is a registered trademark
of Gibson Guitar Corp. MXR and Uni-Vibe are registered trademarks of Dunlop
Manufacturing, Inc. Tycobrahe is a registered trademark of Kurt Stier.
Bypass/Enable REVERB
1. Press the REVERB button to enable the Reverb
2. Press again to switch the Reverb o.
3. Like the EFFECTS, press and hold the REVERB button for two
seconds to enter reverb selection mode. The AMP SELECTOR
encoder LED ring will dim, and you can use the SELECTOR to
scroll through the six dierent reverbs.
Press the REVERB button again to exit selection mode.
Remember to press and hold CH A or B to save your reverb
settings to that preset.
REVERBS
MODEL BASED ON
Hot Spring Line 6 Original
Hall Line 6 Original
Chamber Line 6 Original
Plate Line 6 Original
Ganymede Line 6 Original
Plateaux Line 6 Original
Activate the TUNER
CATALYST includes a simple tuner, utilizing the LEDs above EFFECT,
TAP, and REVERB. When the tuner is engaged, the speaker, Direct Out,
and Phones are muted.
1. Press and hold TAP; Three LEDs light, ashing left to right.
2. If the note is in tune, TAP LED lights WHITE, while the EFFECT
and REVERB LEDs illuminate GREEN.
3. If the note is at, the EFFECT LED illuminates, gradually moving
from RED through to GREEN as you approach in-tune.
4. If the note is sharp, the REVERB LED illuminates from RED
through to GREEN as you approach in-tune.
5. Press any button other than TAP to exit the tuner.
Additional Power User Functionality
Noise Gate - To activate the Noise Gate from the front panel; Press
and hold the BOOST button and turn the BOOST knob.
• From the 9:00~12:00 position, the Noise Gate is bypassed; past
the 12:00 position, the Noise gate is enabled.
Effect Pre/Post Position – CATALYST ampliers allow you to
customize the position of your eects and reverb “Pre” (before the
Amp Voicing) or “Post” (after the Amp Voicing).