User Manual
Table Of Contents
- Contents
- Introduction
- Controls and connectors
- Procedures preparing for use
- Setup and connections
- Configuring the device from a TV screen (on-screen display menu)
- Using Yamaha CS Manager to specify detailed settings
- Appendix
CS-500 User Guide
15
Setup and connections
The following is an example of an installation that uses the screw holes in the TV and a standard TV stand.
1. Attach the monitor mounting bracket (vertical), monitor mounting bracket (for mounting
onto wall mounting bracket) and the wall mounting bracket using the screws included with
them.
2. Using the included screws, attach the monitor mounting brackets (horizontal) and the
brackets assembled in step 1.
Align the monitor mounting brackets (horizontal) with the screw holes in the TV to determine the mounting position.
After determining the mounting position, mount the brackets from step
1 at the appropriate height.
IMPORTANT At this point, do not install the TV yet.
2
1
Monitor mounting
bracket (vertical)
Monitor mounting
bracket
Wall mounting
bracket
[Included with monitor mounting bracket]
Screw for bracket assembly
(M4 × 10 mm with washer) × 6
TV
(back)
[Included with monitor mounting
bracket]
Screw for bracket assembly
(M4 × 10 mm with washer) × 4
Monitor mounting bracket (horizontal)