User Manual
Table Of Contents
- Contents
- Introduction
- Controls and connectors
- Procedures preparing for use
- Setup and connections
- Configuring the device from a TV screen (on-screen display menu)
- Using Yamaha CS Manager to specify detailed settings
- Appendix
CS-500 User Guide
23
Setup and connections
Making necessary initial settings
Activating HDMI connection/DisplayLink function/Bluetooth/USB audio
In order to use this device, activate the functions as described below. Be sure to follow the procedure below before using
this device.
NOTE
• Before performing the following operation, pair the device and remote control (Page 22).
• When this device is used as a webcam (Page 19), this operation is not necessary.
1. Long-press the menu button and camera preset 2 button on the remote control for at least 3
seconds.
Configuration is finished after the status indicator on the front panel of the device flashes in orange five times at a
0.5-second interval.
Installing the DisplayLink
®
driver onto your computer
In order to display the computer screen on a TV, it may be necessary to install the DisplayLink driver (DisplayLink Manager
on a Mac). If the computer screen is not displayed on the TV, even after checking the following, install the DisplayLink driver.
• The device and TV are connected with an HDMI cable.
• The TV input is correctly set.
• The display settings of the computer are set to “duplicate” or “extend” the display.
• The operation described in “Making necessary initial settings” (Page 23) has been performed.
• DisplayLink has been activated in Yamaha CS Manager. (Page 43)
Download the latest DisplayLink driver from the following website.
(The following website is not operated by Yamaha Corporation.)
DisplayLink driver download page
https://displaylink.com/downloads