Owner`s manual

6-9
1
2
3
4
5
6
7
8
9
PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
34
1
ZAUM00**
1. Engine oil drain bolt B
2. O-ring
3. Compression spring
4. Strainer
ECAT1020
cC
When removing the engine oil drain
bolt B, the O-ring, compression
spring, and oil strainer will fall out.
Take care not to lose these parts.
4. Clean the oil strainer with solvent,
and then check it for damage and
replace it if necessary.
5. Check the O-ring for damage and
replace it if necessary.
6. Install the oil strainer, compression
spring, O-ring and engine oil drain
bolt B.
NOTE:
Make sure that the O-ring is properly
seated.
7. Install engine oil drain bolt A, and
then tighten both drain bolts to their
specified torques.
Tightening torque:
Engine oil drain bolt A:
23 Nm (2.3 m • kgf, 16.6 ft • lbf)
Engine oil drain bolt B:
32 Nm (3.2 m • kgf, 23.1 ft • lbt)
1
ZAUM00**
1. Oil filler hole
8. Add the specified amount of the
recommended engine oil, and then
install and tighten the oil filler cap.
Recommended engine oil:
See page 8-1.
Oil change quantity:
0.78 L (0.82 US qt) (0.69 Imp.qt)
ECA11670
cC
88
88
8 Do not use oils with a diesel
specification of “CD” or oils of a
higher quality than specified. In
addition, do not use oils labeled
“ENERGY CONSERVING II” or
higher.
88
88
8 Be sure no foreign material en-
ters the crankcase.
9. Start the engine, and then let it idle
for several minutes while checking
it for oil leakage. If oil is leaking,
immediately turn the engine off and
check for the cause.
10. Turn the engine off, and then check
the oil level and correct it if neces-
sary.
3D1-F8199-11ch6SGML.pmd 2006/08/17, 18:159