Owner`s manual

10
AM
ANT
GND
FM
ANT
75Ω
UNBAL.
Placing the system
This system can be placed any way you like, however, be
sure not to place another unit or any object on top of the
power amplifier (MX-S90) to prevent the ventilation holes on
the top panel of it from being obstructed. If doing so, it may
damage the unit.
Notes
•
If the system is put in a rack, allow a space of at least 5
cm (1-15/16”) above and behind the unit.
•
Disconnect the AC supply lead from the AC outlet before
connecting or disconnecting any component.
Antenna connection
(1) Supplied FM antenna
Connect the FM antenna wire to the corresponding terminal
and direct the FM antenna wire to the direction where the
strongest signal can be received.
(2) Supplied AM (MW/LW) loop antenna
Connect the AM (MW/LW) loop antenna wire to the
corresponding terminals. Position the AM (MW/LW) loop
antenna for optimum reception. Place the AM (MW/LW) loop
antenna on a shelf etc., or install it on the rack or wall with
screws (not supplied).
Notes
•
When static is still heard even after adjusting the position
of the AM (MW/LW) loop antenna, try reversing the
connection (top to bottom).
•
Do not place the AM (MW/LW) loop antenna on the unit. It
will result in noise generation, since the unit is equipped
with digital electronics. Place the AM (MW/LW) loop
antenna away from the unit.
(3) External FM antenna
Use an external FM antenna instead of an indoor FM
antenna if you need better reception. Consult your dealer.
(4) External AM (MW/LW) antenna
Use an external AM (MW/LW) antenna if you need better
reception. Consult your dealer.
Note
When using an external AM (MW/LW) antenna, be sure to
keep the wire of the AM (MW/LW) loop antenna connected.
PREPARATION FOR USE
AM
ANT
GND
FM
ANT
75Ω
UNBAL.
or
Earth rod
7.5 m (25 feet)
15 m (49 feet)
* For Europe model, “AM” is replaced by “MW LW”.
EMPTY
MX-S90 CTX-S90
KX-S90 CDC-S90
Placing example
(1)
(2)
(3)
(4)