Technical information

C
08.06 15
CHAPTER
PAGEISSUE
TWO-STROKE ENGINE AM6
ENGLISH
SECTION 3
C - ENGINE
Minarelli Engine
SECTION 2
F.2
F. 1
1
2
1
F.4
F. 3
1
2
1
2.3 DISASSEMBLY OF THE ENGINE
After removing the spark-plug and carburettor proceed as follows:
1) DRAIN the engine oil by removing the relevant drain bolt.
2) UNSCREW the coolant drainage screw (1-F1); remove the water pump cover by undoing the two fixing
screws (2-F1). Pay attention to the dowel bolts (1-F2).
3) UNDO the fixing screws of the flywheel cover (left hand side) and remove it.
Remove the starter motor (if fitted) by removing the two screws on the crankcase and the screw on the support
strap.
4) Take the carburettor out of its seat; remove the intake union and the relative clutch “bridge”; remove the plate
group (1 - F.3).
5) REMOVE the sprocket (1 - F.4) by removing the snap ring (2 - F.4); using ring pliers, remove the sprocket by
hand and remove the other snap ring underneath the sprocket.