Technical information

C
16 08.06
CHAPTER
PAGE ISSUE
TWO-STROKE ENGINE AM6
ENGLISH
SECTION 2
C - ENGINE
Minarelli Engine
F.6
F.5
1
1
F.8
F.7
2
1
3
3
2
12
3
6) REMOVE the sliding stop screw for starting from clutch side (1 - F.5).
7) REMOVE the fixing screws of the plastic oil pump cap (1 - F.6). Undo the screws securing the oil pump to the
cover; then remove the pump.
8) REMOVE the cover/crankcase fixing screws (of which one M6x55 (2 - F.6), that secure the water pump cover
and the relative clutch cover to the crankcase); now remove the cover (3 - F.6) and its gasket.
9) TAKE the starter assembly OUT of its seat (only for versions with starter pedals), bearing in mind that the any
shim washers must be put in the same position when the component is reassembled.
CAUTION: when disassembling this group, carefully check the position of the pieces so as to
reassemble them correctly afterwards.
10) UNDO the screws compressing the clutch springs (1 - F.7); then remove the clutch plate (2 - F.7) and the
entire set of discs (3 - F.7); remove the disc pusher, the ball and the clutch rod (1, 2, 3 - F.8), which are housed
in the centre hole of the change shaft.