Technical information

C
18 08.06
CHAPTER
PAGE ISSUE
TWO-STROKE ENGINE AM6
ENGLISH
SECTION 2
C - ENGINE
Minarelli Engine
F.16F.15
1
1
F.17
1
2
2
3
3
3
4
15) UNSCREW the nut (2-F.14) with a 19 mm wrench, whilst holding the flywheel in place with the special
wrench; then remove the following parts in this order: drive pinion, countershaft drive gear, key, spacer bushing
and O-ring.
16) BLOCKING the rotor of the magneto flywheel with the special locking wrench (1-F.15), unscrew the rotor
retaining nut with a 15 mm wrench.
17) REMOVE the rotor of the magneto flywheel by means of the appropriate puller (1-F.16), which must be
screwed into the threaded seat of the rotor; whilst holding the latter in place with a wrench, turn the centre
screw.
18) UNDO the screw of the pick up (1-F.17) and REMOVE the stator by loosening the screws (2 - F.17) that
secure it to the plate.
19) TAKE the stator plate OUT of its seat by removing the 3 screws that secure it to the crankcase (3- F.17), and
remove the key (4 - F.17).