Technical information

C
08.06 7
Introduction
CHAPTER
PAGEISSUE
TWO-STROKE ENGINE AM6
ENGLISH
SECTION 1
C - ENGINE
G
O
L
ABBREVIATIONS
F Figure
Cs Tightening torque
P Page
Pr Paragraph
S Section
Sc Diagram
T Table
V Screw
Note:
the letter V in the illustrations refers to retaining or adjusting screws. The number following this letter refers to the
number of the same type of screw in the unit or component described and illustrated. Letters not followed by a
number indicate a single screw. In case of different screws being referred to in the illustration, the letter V is
followed by a number and a small letter, for instance: (V4a).
Unless otherwise specified, units and components are reassembled by proceeding in the reverse order of remov-
al.
OPERATIONAL SYMBOLS
L) LOCTITE
O) Oil lubrication
G) Greasing